Halogeenspot werkt goed.

Mangels Alternativen habe ich diesen Schweinwerfer hier gekauft, trotz unglaublicher 11,. € Versandkosten. Ware kommt in sehr leichtem Karton ungeschützt und ist 2x kaputt angekommen. 1x ohne Funktion, einmal bereits in der Verpackung kaputt (Bruch des Gussteiles!!). Nie wieder hier! Ein Stern ist schon zuviel. Und Lieferung hat auch ewig gedauert!

In der Lieferung waren keine Leuchtmittel beigefügt. Obwohl auf der Bestellseite angezeigt und im Text nicht aufgeführt. Das keine gute Geschäftspraxies!

Packaged well with printed manual. Sturdy mount. Solid aluminium lamp body. Sensor is directional and works over wide area as claimed.Design is kind of 'classic' in that it directly replaced a 20yr old unit: same wall holes/screws, same wiring, same controls (Sens/Time/Dusk). Good seal on front glass and 'electrical boxes'Made to take 400W Halogen (R7s size), but has space to fit fluorescent 'tube' or LED COBB types.Wiring: a bit fiddly, but simple enough. The Earth wire was a bit short, and went under the wiring-block. Not critical. Erh... the Earth wire could have reached more easily if it were in the end connector... ;)Tip: The 2 sprung contacts for the lamp are sufficient, but watch that the silicon sleeves on fluorescent lamps don't prevent eletrical contact (they are designed to 'wedge' in the light fitting, to partly-hold it in place) .Tip: The paint is easily scratched on brickwork, so protect it whilst fitting to a wall etc.Overall, very pleased with this product. Works very well. Would buy another.

This works well once you have got it in place and set up correctly. It’s a bit fiddly to get it right though.This is the same as all the others of this type. You need to connect a long cable to it and then a socket, which can be a bit of work if you haven’t already got one setup before.I bought this as a replacement for an old one where the bulb had died, unfortunately because the screw that keeps the glass lid fixed in place had rusted together, and no way of getting it open without breaking it. So I got a new one of the same type to fit in exactly the same place.The problem, as with all of these type of lights, is that you have to fiddle with the three switches on the light itself. This isn’t easy when they are small and fiddly, and you’re up a ladder, you can’t really see what you’re doing! Then you have to wait for it to get dark to see if the settings that you have chosen are correct, if not, it’s up the ladder again to change the switches until you finally get it correct. This can take many attempts!Once you have got the switches in the correct place for the motion detection and lighting up time, then it works fine, and is nice and bright.I just hope that this one doesn’t rust together like my old one did!